To the construction of log homes to facilitate selection of grooves in the logs, we recommend you use the circular saw. Diameters of logs and saw blade should be roughly equal. Mark out a log and nadpilivayut every 10-15 cm to the line marking, then the sawn sections poked out with an ax.
*
Nail the board to an uneven surface such as a wall log houses, so that the surface of the timber and logs in contact tightly, without gaps, not so easy. The work will be facilitated if we apply a simple copier. Sharpen the end of the line and drill a few holes in it. With a wooden beam to the surface, with whom he has mated, it is possible to partition and accurately handle the timber.
*
Cut a large number of boards of equal length to help rake the desired length, with a focus on the end. Sufficiently sharp to cut the board at one end, and then, using rail as a template, cut them to length.
*
Withstand the construction foundation levelness by using a plumb-line and right-angled triangle with sides of sufficient length. At the corner of formwork for plumb fix a rail-leg, and along the second rail-leg pull cord. He shows a horizontal line of the foundation.
*
To check the accuracy and, if necessary, adjust the level of construction does not require perfectly level surface. Place the tool on a flat surface and mark the position of an air bubble. Then rotate the instrument 180 ° around a vertical axis. If the level is accurate, the bubble deviates up exactly to its original distance from the center of the instrument.
*
Use a measuring tape measure will be more convenient if the metal tape tightly to wear a ring, cut off from hlorvinilovoy tube. Moving the ring on the tape, we can fix the selected size. This saves you from having to remember its meaning. Wooden rulers, especially the long, often shifting the pressure of a pencil while holding the line. That will not happen if the measuring tools to make a small deflection, heating it over the middle of the steam jet nozzle of a boiling kettle. The line will not “go” and if one of the plane covered by a layer of rubber cement.
*
Reverse side of a metal ruler okleyte adhesive tape – it will be easier to operate.
*
On the bench or desktop is very nice to have a ruler. It is best to stick to the end of Bench board – there it is convenient to measure and there it does not hurt. Attach the line to the deepening of the ends. Then it is easy to bend, lift and take up, if required, and then put back into place.
*
Saw deposited on the canvas centimeter graduations for easy operation. Notches can be a chisel or a triangular file.
*
After a small add-on hack-tree can also serve as a quadrangle marking. By the leaf at the very arm priklepyvayut two cubes, so that arm, complete with bars, made an angle of 90 ° with the back of the canvas.
*
To cut the pipe exactly at right angles, eg for subsequent threading, take a flat strip of paper and screw it into the pipe through the cutting device. Plane passing through the edge of the paper will be strictly perpendicular to the axis of the tube.
*
To measure the length of the parts, bent in several directions, apply to the part exactly the entire length of adhesive tape, and then separating the tape, measure its length.
*
To determine the size of the cavity inside the details enough to have on hand micrometer or caliper and caliper riveted to his feet with metal pegs cylindrical shape. Enter your legs calipers in the cavity, dilute them to the limit so that the ends of the legs touched the wall cavity and secure it with a micrometer or calipers pegs position relative to each other. Then remove the caliper, reinstall the pegs in the fixed position and measure the distance between the ends of the legs.
*
When not at hand calipers, and the need to define more precisely the diameter of the cylinder, bolt or screw, insert the measured object in the vise and clamp it tight lips. The distance between the jaws measure a millimeter ruler. This measurement will be much more accurate than direct measurement of the object, especially if it is wrong to whittle away the butt.