Finishing works involve the replacement of damaged or old windows. Typically, the glass thickness from 3 to 4 mm. When ordering a new glass, called the size of 3 mm less than the depth of the grooves, so you can adjust the glass in the grooves. Window frames are rarely completely flat, so measure the glass and on the diagonal. Glass is difficult to adjust the size of even a glass cutter.
If the glass bead is attached, remove them. Then okleyte broken glass criss-cross tape and emboss it to pieces fell into the outstretched box. For glazing must wear gloves.
The old putty shake a bit, trying not to damage the frame. Remove the glass nails that hold the glass in the frame. Postpone them. Clean the grooves of the frame and cover them with primer.
For windows use putty on linseed oil. Roll the putty in the groove and push the frame.
Put the glass in place and push it into putty. Do not put pressure on the middle of the glass. Secure the glass wedges, and nails. Over Apply an even coat of putty so that it formed a smooth beveled edge. Allow putty to dry and two weeks of its special paint paint.
For metal windows, use putty for metal. Before glazing, remove clamps holding the window frame and clean from dirt and rust. Put in place the new glass and Apply frame.